ITI ENGINEERING DRAWING 2019 PAPERS TWO YEAR TRADES
GOVERNMENT OF THE NATIONAL CAPITAL TERRITORY OF DELHI
DEPARTMENT OF TRAINING & TECHNICAL EDUCATION
MUNI MAYA RAM MARG, PITAMPURA, DELHI – 110 088
ALL INDIA TRADE TEST JULY-AUGUST 2019
PAPER-IV (ENGINEERING DRAWING)
ANNUAL SYSTEM (YEAR-I)
ALL 10th PASS TWO YEAR TRADES
TIME: 3 HOURS. Max Marks: 50
Note: Attempt all Questions.
1. Draw the following (Any Four). (5x4=20)
- Neat Sketch of Slotted Nut.
- Any Two Type of Screws with Their Nomenclature.
- Inscribe a Regular Heptagon in a Circle if The Length of One Side of The Heptagon is 20mm.
- A Plain Scale of 1cm=5m And Show 37m on it.
- Free Hand Sketch of Cross Peen Hammer.
2. Figure Shown Below is Horizontal Shaft Bearing. Draw the Following Orthographic Views in third Angle Projection. (10X3=30)
- Elevation View (Front View)
- Side View
- Top View
After Passing iTi Career Option | iTi के बाद क्या करें? Apprentice या Job
Tags: iTi ENGINEERING DRAWING Papers, Previous ED paper, iTi Fitter Papers,iTi Paper2020,ITI ENGINEERING DRAWING 2019 PAPERS TWO YEAR TRADES
0 Comments